Set it on the counter. Set the control panel face up and locate the two screws below the front face panel. Remove these two screws. Next, flip the panel over and release the two locking tabs on both of the top corners. Then you can pry the control panel frame from the main plastic cover.
Pry it free from top to bottom and set the plastic part aside. Remove the parts from the control panel frame. Use a flathead screwdriver to push the tabs back through the holes to release it. Then set it aside. After that, remove the door switch. Pry up the two locking tabs and slide the switch off the frame. Remove the control panel by pressing the locking tabs. One is at the top and two are on the left side. You should be able to hear the locking tabs click as they disengage, and then you can pull it out.
Peel the shield free without ripping it. Stick the shield in place above the on-off switch hole. Add the control board.
Slide the protruding bottom section under the frame and then press it down into position. Make sure all three locking tabs engage. Install the door switch. Line up the top of the door switch with the protruding tabs in the center. Slide it into place until you hear a click. Next, turn the whole frame over and bend the metal locking tabs of the frame down so it holds the door switch in place.
Pick up the on-off switch and orient it so the top is facing the top of the frame. Line up the four tabs on the side with the four L-shaped cutouts in the control panel frame. Set the plastic top panel face down and line up the control panel frame on top of it, shield side facing up. Press down on the top two corners to engage the locking tabs. Turn the two connected pieces over, and secure them with the two screws under the nameplate. Reconnect the wiring.
Remember Me? Advanced Search. Results 1 to 12 of Thread: How to install speakers into Integra doors. How to install component speakers into a DC5 Integra. You follow these steps at your own risk! So without further ado; here we go. Also; although this is only one particular Integra the concept is the same across the entire range. Step one: Take one original door complete from factory.
Give them a nice clean and remove any debris and dust. Step two: Apply sound deadening to the entire outer skin. Step three: Add diffuser panels behind the speaker to combat wave reflections. Step four: Run your aftermarket speaker cables through the loom tubes into the doors.
This ensures you have adequately sized cables for higher current flow as the factory speaker cables are not overly large. Step five: Make the baffles in a similar shape to the factory drivers. These must locate through the factory holes to avoid damaging the door, thus meaning when you sell the car the factory speakers can go right back in.
Here are the steps-. Your email address will not be published. Currently you have JavaScript disabled. In order to post comments, please make sure JavaScript and Cookies are enabled, and reload the page. Click here for instructions on how to enable JavaScript in your browser. Here are some tips on how to replace an integrated dishwasher door- How to remove the dishwasher door Depending on the model of an integrated dishwasher, the nature of the attachment of the door varies.
Loading recommendations Share on Facebook Share. Share on Twitter Tweet. Share on Pinterest Share. Share on Digg Share. Some details about the types of dishwasher.
0コメント